System time
5.4 PTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
162 Configuration Manual, 11/2015, C79000-G8976-C252-10
This section describes commands with which you display various settings.
show ptp info
Description
This command shows the current settings for the Precision Time Protocol (PTP).
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ptp info [ interfaces <interface-type> <interface-id> ]
The parameters have the following meaning:
Keyword for a an interface name.
Type or speed of the interface.
Enter a valid interface name.
Slot no. and port no. of the interface.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The current settings for the Precision Time Protocol (PTP) are displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General