Layer 2 management protocols
8.5 Unicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
418 Configuration Manual, 11/2015, C79000-G8976-C252-10
The unicast blocking settings for ports are displayed.
show mac-address-table dynamic unicast
Description
This command shows the table with the dynamic unicast MAC addresses assigned by the
device.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show mac-address-table dynamic unicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>
<interface-id>}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a MAC address
MAC address -
Keyword for a an interface description
Type or speed of the interface Enter a valid interface
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
The dynamic unicast MAC addresses are displayed.
To Next Page
Loading...
Need help?
General