Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
765
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call the command without parameters:
clear logbook
The content of the logbook is deleted.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you change to the EVENTS configuration mode.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
events
To Next Page
Loading...
Need help?
General