Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
67
Call up the command with the following parameters:
show multicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Keyword for a port description
Type of interface Enter a valid interface
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If no parameters are specified, the settings for all ports are displayed.
The multicast blocking settings for ports are displayed.
show traceroute
Description
This command shows the route via which the packet comes to the requested IP address-
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show traceroute {ip | ipv6 }
The parameters have the following meaning:
The destination is an IPv4 address -
The destination is an IPv6 address
The route is displayed.
To Next Page
Loading...
Need help?
General