Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
90 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
no duplex
The duplex mode of the Interface is reset to the default value.
You configure the duplex mode of the interface with the duplex command.
With this command, you enable the sending and receipt of LLDP packets on the interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
lldp{transmit|receive}
The parameters have the following meaning:
The sending of LLDP packets is ena-
Default: enabled
The receipt of LLDP packets is ena-
bled.
Default: enabled
Note
Enabling both options
When you call this command, you can only select one option.
If you want to enable both options, call up the command again.
To Next Page
Loading...
Need help?
General