Load control
10.1 Rate control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
650 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show rate-limit output[interface<interface-type><interface-id>]
The parameters have the following meaning:
Keyword for a an interface description
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
The entries are displayed.
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
rate-limit output
Description
With this command, you configure and enable the data rate in Kbps for limiting the outgoing
data stream of the interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
To Next Page
Loading...
Need help?
General