Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.7 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
357
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp notify <NotifyName>
The parameter has the following meaning:
Parameter
Description
Range of values / note
NotifyName
Name of the notification
max. 32 characters
Result
The details of the SNMP notifications are deleted.
Further notes
You change the details of an SNMP group with the snmp notify command.
You display the configured SNMP notifications with the
show snmp notif command.
You display the configured SNMP target addresses with the
show snmp targetaddr
command.
7.7.2.12
snmp targetaddr
Description
With this command, you configure the SNMP target address.
Requirement
● The SNMP target parameters are configured.
You are in the Global configuration mode.
The command prompt is:
cli(config)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English