Configuration
3.5 PoE
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
119
This section describes commands with which you display various settings.
Note
The interface is a Gigabit Ethernet interface.
show poe status
Description
This command shows specific information for all or for a selected PoE interface (PoE: Power
over Ethernet).
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show poe status [interface <interface-type> <interface-id>]
The parameters have the following meaning:
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
If you use the command without setting parameters, information about all PoE interfaces is
displayed.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The information for the selected PoE interface is displayed.
To Next Page
Loading...
Need help?
General