Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
604 Configuration Manual, 11/2015, C79000-G8976-C252-10
Note
These commands are available only with layer 3.
ip rip default route originate
Description
This command enables the forwarding of a default route.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
ip rip default route originate <metric(1-15)>
The parameter has the following meaning:
Value for the metric information.
The default route is forwarded.
no ip rip default route originate
Description
This command disables the distribution of the default routes.
To Next Page
Loading...
Need help?
General