Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
209
no port-channel load-balance
Description
With this command, you reset the load balancing policy for the interconnected ports of the
previously defined port channels to the default.
The default value is
src-dest-mac.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no port
-channel load
-balance [<port
-channel-index(1-8)>] The parameter has the following meaning:
Number of the port channel
If you do not enter a value for port-channel-index, the setting is used for all port channels.
The load balancing policy is reset to the default value.
You can change the setting for the load balancing policy with the port-channel load-balance
command.
You can display the status of this function and other settings with the
show etherchannel
command.
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General