Load control
10.5 Service classes
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
671
Commands in the QOS configuration mode
This section describes commands that you can call up in the QOS configuration mode.
In the Global configuration mode, enter the
qos command to change to this mode.
● If you exit the QOS configuration mode with the
exit command, you return to the Global
configuration mode.
● If you exit the QOS configuration mode with the
end command, you return to the
Privileged EXEC mode.
In a network, each data stream is assigned a service class that decides its priority. In special
situations, it may be necessary to change this priority.
This change is made using a table in which the service classes are assigned to another
queue.
With this command, you configure the assignment table for service classes.
With queues 1 - 6 frames with a lower priority are occasionally processed even if there are
frames with high priority in the queue.
With queues 7 - 8 only frames with a high priority are processed as long as there are frames
with high priority in the queue.
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
To Next Page
Loading...
Need help?
General