Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
300 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
ipv6 address <prefix> link-local
The parameter has the following meaning:
Link local address Specify a valid link local address.
fe80::XXXX:XXXX:XXXX:XXXX
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The link local address is assigned to the interface.
You delete the link local address with the no ipv6 address link-local command.
You display this setting and other information with the
show ipv6 interface command.
no ipv6 address link-local
Description
With this command, you delete the link local address.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
To Next Page
Loading...
Need help?
General