Configuration
3.6 NFC (SCALANCE XM-400 only)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
130 Configuration Manual, 11/2015, C79000-G8976-C252-10
NFC (SCALANCE XM-400 only)
3.6.1
This section describes commands with which you display various settings.
show nfc active status
Description
This command shows whether or not the NFC function (Near Field Communication) is
activated or deactivated.
Note
You will find further information on NFC in the operating instructions "SCALANCE XM
-400".
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show nfc active status
The status of the NFC function is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General