Security and authentication
11.7 Port Based Network Access Control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
743
A list with guest VLAN, MAC address and port is displayed.
show dot1x mac-auth mac-info
Description
This command shows the MAC addresses for which MAC authentication is enabled.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show dot1x mac-auth mac-info
A list of the MAC addresses is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
dot1x guest-vlan
Description
With this command, you enable the guest VLAN function for the device.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General