Siemens SCALANCE XR-500 Configuration Manual

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
78 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder
$$$ is replaced by the following name of the interface:
Type of interface
Command prompt
cpu0
cli(config-if-cpu0)#
vlan
cli(config-if-vlan-$)#
port-channel
cli(config-if-po-$)#
gigabitethernet
cli(config-if-Gi$-$)#
extreme-ethernet
cli(config-if-Ex$-$)#
The placeholders $ or $-$ denote the numbering of the interface.
The ranges of values for the logical interfaces VLAN and port channel can be found in the
table above. You can only call up interfaces that you created with the
vlan or channel-group
command.
The ranges of values from the physical interfaces depend on the hardware configuration.
Further notes
You exit the Interface configuration mode with the end or exit command.
You delete a logical interface with the
no interface command.
You display the status and the configuration of the interfaces with the
show interfaces
command.
3.1.12.2
no interface
Description
With this command, you delete a logical interface.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English