Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
238 Configuration Manual, 11/2015, C79000-G8976-C252-10
no spanning-tree mst
Description
With this command, you reset the various properties of the Multiple Spanning Tree function
to the default value.
The default values are as follows:
• 200000 for physical interfaces
• 199999 for port channels
128
The Multiple Spanning Tree function is enabled on the interface
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
no spanning-tree mst<instance-id(1-64)>{cost|port-priority|disable}
The parameters have the following meaning:
Number of the addressed instance
Keyword for the costs of the port for
calculating the lowest-cost path.
-
Keyword for the priority of the interface
Enables the interface for multiple
-
Note
Configure multiple properties
Wit
h each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
The selected setting is reset to the default value.
To Next Page
Loading...
Need help?
General