Network protocols
7.12 SSH server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
383
You change the timeout setting with the arp timeout command.
You can display the status of this function and other information with the
show ip arp
command.
This section describes commands of the Secure Shell (SSH) Server.
This section describes commands with which you display various settings.
This command shows the settings of the SSH server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip ssh
The settings for the SSH server are displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General