Siemens SCALANCE XR-500 Configuration Manual

Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
434 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
The purge time is configured.
Further notes
You can reset the setting to the default with the ipv6 mld snooping port-purge-interval
command.
You can display the status of this function and other information with the
show ipv6 mld
snooping globals
command.
8.7.2.5
no ipv6 mld snooping port-purge-interval
Description
With this command, you reset the setting for the purge time to the default value.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ipv6 mld snooping port-purge-interval
Result
The purge time is reset to the default value.
Further notes
You configure the setting with the ipv6 mld snooping port-purge-interval command.
You can display the status of this function and other information with the
show ipv6 mld
snooping globals
command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English