Diagnostics
12.5 RMON
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
808 Configuration Manual, 11/2015, C79000-G8976-C252-10
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you enable the Remote Monitoring function.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
rmon
Default: disabled
The Remote Monitoring function is enabled.
You disable this function with the no rmon command.
You can display the status of this function and other information with the
show rmon
command.
With this command, you disable the Remote Monitoring function.
To Next Page
Loading...
Need help?
General