Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
641
Call up the command with the following parameters:
no match next-hop ipv6 <next hop IPv6 address>
The parameter has the following meaning:
dress
IPv6 address Enter the IPv6 address of the router to which the routing infor-
mation will be sent next.
The filter for the next router (IPv6) is deleted.
You create a filter for the next router (IPv6) with the match next-hop ipv6 command.
You create a filter for the next router (IPv4) with the
match next-hop ip command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
match route-type
Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the type of the route.
vailable only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
To Next Page
Loading...
Need help?
General