Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
432 Configuration Manual, 11/2015, C79000-G8976-C252-10
MLD snooping is enabled.
You disable GMRP with the no grmp command.
You disable MLD snooping with the
no ipv6 mld snooping command.
You display the setting and other information with the
show ipv6 mld snooping and show ipv6
mld snooping globals
commands.
no ipv6 mld snooping
Description
With this command, you disable MLD snooping on the device or on the required VLAN.
You are in the Global configuration mode or in the VLAN configuration mode.
The command prompt is in the Global configuration mode is:
cli(config)#
or in the VLAN configuration mode:
cli(config-vlan-$$$)#
Call the command without parameter assignment:
no ipv6 mld snooping
MLD snooping is disabled.
You enable MLD snooping with the ipv6 mld snooping command.
ipv6 mld snooping clear counters
Description
With this command, you reset the counters of the MLD snooping statistics to zero.
To Next Page
Loading...
Need help?
General