Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
540 Configuration Manual, 11/2015, C79000-G8976-C252-10
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
ipv6 ospf metric <metric>
The parameter has the following meaning:
Value for the metric 1 ... 65535
The metric is specified.
You enable OSPFv3 routing with the ipv6 router ospf command.
You can reset the metric to the default with the
no ipv6 ospf metric command.
You display the configuration with the
show ipv6 ospf interface command.
no ipv6 ospf metric
Description
With this command, you reset the metric back to the default value.
is available only with layer 3.
To Next Page
Loading...
Need help?
General