Security and authentication
11.7 Port Based Network Access Control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
754 Configuration Manual, 11/2015, C79000-G8976-C252-10
cli(config-if-$$$)#
Call the command without parameters:
no dot1x port-control
The port control parameter of the authenicator is reset to the default value.
You configure the port control parameter with the dot1x port-control command.
You can display the status of this function and other information with the
show
dot1x
command.
set dot1x mac-auth mac-addr count
Description
With this command, you specify how many MAC addresses can be authenticated on the port
at the same time.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
set dot1x mac-auth mac-addr count <num-of-addresses (1-100)>
The parameter has the following meaning:
Maximum number of devices
The maximum number of devices for the port has been specified.
To Next Page
Loading...
Need help?
General