Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
91
Sending or receipt of LLDP packets is enabled.
You disable the sending or receipt of LLDP packets with the no lldp command.
With this command, you disable the sending or receipt of LLDP packets on the interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
no lldp{transmit|receive}
The parameters have the following meaning:
the sending of LLDP packets is disabled
the receipt of LLDP packets is disabled
Note
Disabling both options
When you call this command, you can only select one option.
If you want to disable both options, call up the command again.
Sending or receipt of LLDP packets is disabled.
You enable the sending or receipt of LLDP packets with the lldp command.
To Next Page
Loading...
Need help?
General