Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
614 Configuration Manual, 11/2015, C79000-G8976-C252-10
Further notes
You reset the administrative distance to the default with the no distance command.
9.7.3.2
no distance
Description
With this command, you reset the administrative distance back to the default value.
Requirement
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Syntax
Call up the command with the following parameters:
no distance [route-map <name(20)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
route-map
Keyword for a route map
-
name
Name of the route map
Maximum of 20 characters.
Result
The value for the administrative distance is reset.
Further notes
You specify the administrative distance with the distance command.
9.7.3.3
distribute prefix
Description
This command enables the filtering of the routing information according to an IPv6 address
for incoming or outgoing routing information.
Note
This command is available only with layer 3.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English