Security and authentication
11.4 IP access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
706 Configuration Manual, 11/2015, C79000-G8976-C252-10
Note
IP access control lists are available only with IPv4.
Note
Refer to the information and restrictions in section "
Configuration limits (Page 34)".
This section describes commands for working with IP access control lists.
This section describes commands with which you display various settings.
show access-lists
Description
This command shows the configuration of the access control lists (Access Control List).
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show access
-lists [ [{ip | mac}] <access
-list-number (1
-128)> ]
The parameters have the following meaning:
Selects IP-based access lists (IP ACL)
Selects MAC-based access lists (MAC
-
Number of the access control list
If you do not select any parameters from the parameter list, the configuration of all access
control lists will be displayed.
To Next Page
Loading...
Need help?
General