Security and authentication
11.3 MAC access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
703
Commands in the MAC ACL configuration mode
This section describes commands that you can call up in the MAC ACL configuration mode.
In the Global configuration mode, enter the
mac access-list extended command to change
to this mode.
● If you exit the MAC ACL configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the MAC ACL configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you configure a MAC address control list that describes the MAC
addresses for which incoming and/or outgoing data traffic is permitted.
The access control list contains only one entry. If you want to lock or permit further
addresses, create a new access control list.
Note
Processing order of the lists
The access
control lists are processed on the interface in the order in which they were
The index number of the access control list is not used for this.
You are in the MAC ACL configuration mode.
The command prompt is as follows:
cli(config-ext-macl)#
Call up the command with the following parameters:
permit {any|host<src-mac-address>}{any|host<dest-mac-address>}
The parameters have the following meaning:
Keyword for the MAC address of an
incoming connection that is permitted
-
To Next Page
Loading...
Need help?
General