Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
399
no ip igmp snooping port-purge-interval
Description
With this command, you reset the setting for the purge time to the default value.
The default value is 260 seconds.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no ip igmp snooping port-purge-interval
The purge time is reset to the default value.
You configure the setting with the ip igmp snooping port-purge-interval command.
You can display the status of this function and other information with the
show ip igmp
snooping globals
command.
Commands in the VLAN configuration mode
This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
vlan $$$ command to change to this mode.
When doing this, you need to replace the
$$$ placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General