Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
76 Configuration Manual, 11/2015, C79000-G8976-C252-10
The messages relating to the response of the called node are displayed.
With this command you enable the following of the route via which the packet comes to the
requested IP address.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call up the command with the following parameters:
traceroute {ip <ip-address> | ipv6 <ip6-address>}
The parameters have the following meaning:
Keyword for an IPv4 address
IPv4 address of the destination Enter a valid IPv4 address.
Keyword for an IPv6 address
IPv6 address of the destination
Enter a valid IPv6 address.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The tracing of the route is activated.
You display the route with the show traceroute command.
To Next Page
Loading...
Need help?
General