Siemens SCALANCE XR-500 Configuration Manual

Diagnostics
12.3 Loop detection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
787
Further notes
You can display the status of this function and other information with the show loopd
command.
12.3.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
12.3.2.1
loopd
Description
With this command, you enable the loop detection function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
loopd
Result
The loop detection function is enabled
Further notes
You disable the function with the no loopd command.
You can display the status of this function and other information with the
show loopd
command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English