Siemens SCALANCE XR-500 Configuration Manual

Description
2.7 General CLI commands
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
49
Entry and appearance
The entry of IPv6 addresses is possible in the notations described above. IPv6 addresses
are always shown in the hexadecimal notation.
2.7
General CLI commands
This section describes commands that you can call up in any mode.
2.7.1
clear screen
Description
With this command, you clear the screen.
The command prompt is displayed.
Syntax
Call the command without parameters:
clear screen
Result
The screen is cleared.
The command prompt is displayed.
2.7.2
end
Description
With this command, you exit the configuration mode and are then in the Privileged EXEC
mode.
Requirement
You are in a configuration mode.
Syntax
Call the command without parameters:
end

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English