Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
436 Configuration Manual, 11/2015, C79000-G8976-C252-10
You display the setting and other information with the show ipv6 mld snooping and show ipv6
mld snooping globals
commands.
no ipv6 mld snooping
Description
With this command, you disable MLD snooping on the device or on the required VLAN.
You are in the Global configuration mode or in the VLAN configuration mode.
The command prompt is in the Global configuration mode is:
cli(config)#
or in the VLAN configuration mode:
cli(config-vlan-$$$)#
Call the command without parameter assignment:
no ipv6 mld snooping
MLD snooping is disabled.
You enable MLD snooping with the ipv6 mld snooping command.
ipv6 mld snooping querier
Description
With this command, you configure the MLD snooping on the device as querier for a specific
VLAN.
To Next Page
Loading...
Need help?
General