Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
526 Configuration Manual, 11/2015, C79000-G8976-C252-10
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf passive-interface
Result
The configuration is active.
Further notes
You enable the configuration with the passive-interface command.
You can display the status of this function and other information with the
show ipv6 ospf
interface
command.
9.3.3.14
redist-config
Description
With this command, you configure the information for external routes. The routes are further
distributed with this information
Note
This command is available only with la
yer 3.
Requirement
● The router is an ASBR router.
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English