Security and authentication
11.6 Management Access Control List
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
740 Configuration Manual, 11/2015, C79000-G8976-C252-10
If optional parameters are not specified when configuring, the manager is authorized for all
services.
Note
Configuration of the first entry
As long as the list of authorized managers is empty, access to the system is not restricted.
As soon as the list contains an entry and the "authorized
-manager" command is executed,
access to the system is blocked for all others.
You should therefore configure the interface via which you access the system first because
your access is otherwise blocked.
The interfaces and protocols via which an authorized manager is allowed to access the
device are configured.
Note
No restrictions for console port
The restrictions do not apply to the serial console (console port).
You delete an interface for access of an authorized manager with the no authorized-manager
ip-source
command.
You show the information about the configuration of the authorized managers with the
show
authorized-manager
command.
no authorized-manager ip-source
Description
With this command, you delete an interface via which an authorized manager is allowed to
access the device.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General