Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
466 Configuration Manual, 11/2015, C79000-G8976-C252-10
no compatible rfc1583
Description
With this command, you disable compatibility with RFC 1583.
Note
This command is available only with layer 3.
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Call the command without parameters:
compatible rfc1583
The compatibility with RFC 1583 is disabled.
You enable the compatibility with the compatible rfc1583 command.
You can display the status of this function and other information with the
show ip
ospf
command.
default-information originate
Description
With this command, you enable the function with which a standard route is generated for
external routes into the OSPF routing domain.
Note
This command is available only with layer 3.
To Next Page
Loading...
Need help?
General