Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
763
● The interface has no active data traffic.
● The
cabletest interface function was used on the specified interface in the Global
configuration mode.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is:
cli> or cli#
Call up the command with the following parameters:
show cabletest interface <interface-type> <interface-id>
The parameters have the following meaning:
Enter a valid interface.
Interface identifier
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The result is displayed.
You enable the cable test function with the cabletest interface command in the Global
configuration mode.
show interface transceiver details
Description
This command runs error diagnostics for an SFP port.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General