Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
305
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
ipv6 nd suppress-ra
IPv6 router advertisement packets are not distributed.
You enable IPv6 routing with the ipv6 unicast-routing command.
You display this setting and other information with the
show ipv6 interface command.
You enable the distribution of IPv6 router advertisement packets with the command
no ipv6
nd suppress-ra
.
no ipv6 nd suppress-ra
Description
With this command, you enable the distribution of IPv6 router advertisement packets.
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
no ipv6 nd suppress-ra
To Next Page
Loading...
Need help?
General