Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
493
The interval is specified.
You delete the interval with the no ip ospf retransmit-interval command.
no ip ospf retransmit-interval
Description
With this command, you delete the interval.
Note
This command is available only with layer 3.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call the command without parameter assignment:
no ip ospf retransmit-interval
The interval is deleted.
You configure the interval with the ip ospf retransmit-interval command.
You configure the router port with the
no switchport command.
To Next Page
Loading...
Need help?
General