Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
302 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameter assignment:
ipv6 enable
IPv6 is enabled.
You configure an IPv6 address with the ipv6 address command.
You display this setting and other information with the
show ipv6 interface command.
You enable IPv6 routing with the ipv6 unicast-Routing command.
ipv6 interface-identifier
Description
With this command, you configure the interface ID. The interface ID uniquely identifies the
IPv6 interface on the link. Along with the prefix, the interface ID forms the IPv6 address, see
Structure of an IPv6 address (Page 47).
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
ipv6 interface
-identifier <prefix>
The parameter has the following meaning:
Interface ID Enter an interface ID.
To Next Page
Loading...
Need help?
General