Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
406 Configuration Manual, 11/2015, C79000-G8976-C252-10
show ring-redundancy
Description
With this command, you show the current configuration of the ring redundancy and standby
functions.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ring-redundancy
The current configurations are displayed.
show ring-redundancy manager counters
Description
With this command, you display the following information:
● How often the device as redundancy manager switched to the active status, i.e. closed
the ring.
● The maximum delay time of the test frames of the redundancy manager.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ring-redundancy manager counters
To Next Page
Loading...
Need help?
General