Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
568 Configuration Manual, 11/2015, C79000-G8976-C252-10
You configure a VRRP interface with the interface command.
You enable routing with VRRP with the
router vrrp command.
You reset the time interval to the default with the
no vrrp timer command.
You assign IP addresses to a virtual router with the
vrrp associated-ip command.
You show the interval with the
show vrrp interface - vrid command.
no vrrp timer
Description
With this command, you reset the time interval to the default value.
Note
This command is available only with layer 3.
● Routing with VRRP is enabled.
● An IPv4 address is assigned to the virtual router.
● You are in the VRRP Interface configuration mode
.The command prompt is:
cli (config-vrrp-if)#
Call up the command with the following parameters:
no vrrp <vrid(1-255)> timer
The parameter has the following meaning:
The time interval is reset.
You configure a VRRP interface with the interface command.
You enable routing with VRRP with the
router vrrp command.
You configure the interval with the
vrrp timer command.
You assign IPv4 addresses to a virtual router with the
vrrp ipv4 command.
You show the interval with the
show vrrp interface - vrid command.
To Next Page
Loading...
Need help?
General