System time
5.3 SNTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
155
Call up the command with the following parameters:
ntp time diff <(+/-hh:mm)>
The parameter has the following meaning:
Time zones to the west of the NTP server time zone
Time zones to the east of the NTP server time zone
Number of hours difference
Number of minutes difference
Enter the number of hours and number of minutes with two digits each.
Default: No time difference.
The time difference between the device and the NTP server is configured.
This section describes commands relevant for configuration of the SNTP client.
This section describes commands with which you display various settings.
show sntp status
Description
This command shows the settings of the Simple Network Time Protocol.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show sntp status
To Next Page
Loading...
Need help?
General