Load control
10.1 Rate control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
653
The storm control function is enabled.
You enable the function with the no storm-controlcommand.
You configure the threshold value for the storm control function with the
storm-control level
command.
no storm-control
Description
With this command, you disable the storm control function for broadcast, multicast or
unknown unicast packets.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
no storm-control{broadcast|multicast|dlf}
The parameters have the following meaning:
Disables broadcast storm control
Disables multicast storm control
Disables unknown unicast storm control
if you call up the function without parameters, it is disabled for all types of transmission.
The storm control function is disabled.
You enable the function with the storm-control command.
To Next Page
Loading...
Need help?
General