Diagnostics
12.4 Port Mirroring
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
797
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you enable the port mirroring function.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
monitor
As default the function is "disabled".
The port mirroring function is enabled.
You can display the status of this function with the show monitorcommand.
You disable the function with the
no monitor command.
With this command, you disable the port mirroring function.
To Next Page
Loading...
Need help?
General