Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
492 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
no ip ospf message-digest-key <Key-ID (0-255)>
The parameter has the following meaning:
The password is deleted.
You specify the password with the ip ospf message-digest-key command.
ip ospf retransmit-interval
Description
With this command, you specify the time after which an LSA message is transferred again if
no confirmation has been received.
Note
This command is available only with layer 3.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call up the command with the following parameters:
ip ospf retransmit-interval <seconds (0 - 3600)>
The parameter has the following meaning:
To Next Page
Loading...
Need help?
General