Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
407
The counters are displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
ring-redundancy configuration
Description
With this command, you change to the Redundancy Configuration mode.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
ring-redundancy configuration
You are now in the Redundancy Configuration mode.
The command prompt is as follows:
cli(config-red)#
You exit the Redundancy Configuration mode with the end or exit command.
To Next Page
Loading...
Need help?
General