Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
451
no router ospf
Description
With this command, you disable routing with OSPF.
Note
This command is available only with layer 3.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
no router ospf
Routing with OSPF is disabled.
You enable routing with OSPF with the router ospf command.
Commands in the Router Configuration mode
This section describes commands that you can call up in the Router configuration mode.
In the Global configuration mode, enter the
router ospf command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the Router configuration mode with the
exit command, you return to the Global
configuration mode.
● If you exit the Router configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General