Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
640 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
match next-hop ipv6 <next hop IPv6 address>
The parameter has the following meaning:
dress
IPv6 address Enter the IPv6 address of the router to which the routing infor-
mation will be sent next.
The filter for the next router (IPv6) is created.
You delete the filter for the next router (IPv6) with the no match next-hop ipv6 command.
You create a filter for the next router (IPv4) with the
match next-hop ip command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
no match next-hop ipv6
Description
With this command, you delete the filter for the next router (IPv6).
Note
This command is available only with layer 3 (IPv6).
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
To Next Page
Loading...
Need help?
General