Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
546 Configuration Manual, 11/2015, C79000-G8976-C252-10
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf retransmit-interval
Result
The interval is reset.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You configure the interval with the
ipv6 ospf retransmit-interval command.
You display the configuration with the
show ipv6 ospf interface command.
9.3.4.17
ipv6 ospf transmit-delay
Description
With this command you specify the time that a link state update packet requires for
transmission.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English