Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
552 Configuration Manual, 11/2015, C79000-G8976-C252-10
You disable routing with VRRP with the no router vrrp command.
no router vrrp
Description
With this command, you disable routing with VRRP.
Note
This command is available only with layer 3.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
no router vrrp
Routing with VRRP is disabled.
You enable routing with VRRP with the router vrrp command.
Commands in the VRRP Router Configuration mode
This section describes commands that you can call up in the VRRP Router Configuration
mode.
In the Global Configuration mode, enter the
router vrrp command to change to this mode.
● If you exit the VRRP Router Configuration mode with the
exit command, you return to
the Global Configuration mode.
● If you exit the VRRP Router Configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General